check_hw_sensors - monitors sysctl hw.sensors on OpenBSD
    check_hw_sensors [-i] (-f [<FILENAME>]|(-s <hw.sensors id> [-w limit] [-c limit]))

Usage:
    -i, --ignore-status
        Don't automatically check the status of sensors that report it.
    -f, --filename=FILE
        FILE to load checks from (defaults to /etc/sensorsd.conf)
    -s, --sensor=ID
        ID of a single sensor.  "-s kate0.temp0" means hw.sensors.kate0.temp0
        Overrides --filename.
    -w, --warning=RANGE or single ENTRY
        Exit with WARNING status if outside of RANGE or if != ENTRY
    -c, --critical=RANGE or single ENTRY
        Exit with CRITICAL status if outside of RANGE or if != ENTRY

FILE is in the same format as sensorsd.conf(5) plus some additional
entries.  These additional entries in the file are ignored by
sensorsd(8) this means you can use the same config file for check_hw_sensors
as well as sensorsd(8).

check_hw_sensors understands the following entries:

    low, high, crit, warn, crit.low, crit.high, warn.low, warn.high,
    ignore, status

An ENTRY depends on the type.  The descriptions in sensorsd.conf(5)
can be used when appropriate, or you can use the following:

    fanrpm, volts_dc, amps, watthour, amphour, integer (raw), percent,
    lux or timedelta - Anything that includes digits.  Both the value of
    the check and the value of the sensor response that are not either a
    digit or period are stripped and then the two resultant values are
    compared.

    temp - Can be as above, but if the entry has an F in it,
    it compares farenheit, otherwise it uses celcius.

    indicator or drive - does a case sensitive match of each
    entry in the comma separated list and if it does not match
    any of the entries, it sets the status.

The entries 'crit' or 'warn' (or the -c or -w on the command line)
may be a RANGE or a comma separated list of acceptable values.
The comma separated list of values contains a list of things that
will NOT cause the status.  This is possibly counterintuitive, but
you are more likely to know good values than bad values.

A RANGE is a low ENTRY and a high ENTRY separated by a colon (:).
It can also be low: or :high with the other side left blank to only
make the single check.

An entry marked "ignore" will cause that sensor to be skipped.
Generally used with state checking of all sensors to ignore sensors you
don't care about or that report incorrectly.

If you are using --ignore-status, you can still check the status of
individual sensors with a status entry.

check_hw_sensors v1.26
Copyright (c) 2009 Andrew Fresh <andrew@afresh1.com>
Permission to use, copy, modify, and distribute this software for any
purpose with or without fee is hereby granted, provided that the above
copyright notice and this permission notice appear in all copies.

THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.