[BACK]Return to check_hw_sensors CVS log [TXT][DIR] Up to [local] / nagios / check_hw_sensors

Diff for /nagios/check_hw_sensors/check_hw_sensors between version 1.16 and 1.17

version 1.16, 2006/10/25 19:36:46 version 1.17, 2006/10/26 00:30:23
Line 1 
Line 1 
 #!/usr/bin/perl -T  #!/usr/bin/perl -T
 # $RedRiver: check_hw_sensors,v 1.15 2006/10/25 18:35:59 andrew Exp $  # $RedRiver: check_hw_sensors,v 1.16 2006/10/25 18:36:46 andrew Exp $
 ########################################################################  ########################################################################
 # check_hw_sensors *** A nagios check for OpenBSD hw.sensors  # check_hw_sensors *** A nagios check for OpenBSD hw.sensors
 #  #
Line 424 
Line 424 
   
 Usage:  Usage:
     -i, --ignore-status      -i, --ignore-status
         Whether to check the "status" of the sensors that report it.          Don't check the status of sensors that report it.
         Normally enabled, pass this  
     -f, --filename=FILE      -f, --filename=FILE
         FILE to load checks from (defaults to /etc/sensorsd.conf)          FILE to load checks from (defaults to /etc/sensorsd.conf)
     -s, --sensor=ID      -s, --sensor=ID
Line 434 
Line 433 
         Exit with WARNING status if outside of RANGE or if != ENTRY          Exit with WARNING status if outside of RANGE or if != ENTRY
     -c, --critical=RANGE or single ENTRY      -c, --critical=RANGE or single ENTRY
         Exit with CRITICAL status if outside of RANGE or if != ENTRY          Exit with CRITICAL status if outside of RANGE or if != ENTRY
   
     -h (--help)       usage help  
   
 FILE is in the same format as sensorsd.conf(5) plus some additional  FILE is in the same format as sensorsd.conf(5) plus some additional
 entries.  These additional entries in the file are ignored by  entries.  These additional entries in the file are ignored by
Legend:
Removed from v.1.16  
changed lines
  Added in v.1.17
FreeBSD-CVSweb <freebsd-cvsweb@FreeBSD.org>